Troubleshooting guide, Power-related problems – Canon EOS 80D User Manual

Page 481

Advertising
background image

481

If a problem occurs with the camera, first consult this Troubleshooting
Guide. If this Troubleshooting Guide does not resolve the problem,
contact your dealer or nearest Canon Service Center.

If the battery’s remaining capacity is 94% or higher, the battery will not
be recharged (p.452).

Do not use any battery other than a genuine Battery Pack LP-E6N/LP-
E6.

If (1) the battery charger or battery has a problem or (2) communication
with the battery failed (with a non-Canon battery), the protection circuit
will stop charging, and the charge lamp will blink in orange at a high
speed. In the case of (1), unplug the charger’s power plug from the
power outlet. Detach and reattach the battery to the charger. Wait a few
minutes, then reconnect the power plug to the power outlet. If the
problem persists, contact your dealer or nearest Canon Service Center.

If the internal temperature of the battery attached to the charger is high,
the charger will not charge the battery for safety reasons (lamp off). If
the battery temperature becomes high for any reason during charging,
the charging will stop automatically (lamp blinks). When the battery
temperature goes down, the charging will resume automatically.

Make sure the battery is installed properly in the camera (p.36).

Make sure the battery compartment cover is closed (p.36).

Make sure the card slot cover is closed (p.37).

Recharge the battery (p.34).

Troubleshooting Guide

Power-Related Problems

The battery does not recharge.

The charger’s lamp blinks at high speed.

The charger’s lamp does not blink.

The camera does not operate even when the power switch is set to <1>.

Advertising