HP MSL6000 Series - Manual (Page 15)

MSL6000 series tape library user guide 15
1 Introduction
Designed for backup operations with high-end networks and high-performance servers, the HP
StorageWorks MSL 6000 Series tape libraries are the next generation performers in high-volume
backup and archival service. The libraries also feature high availability, maximum storage density,
and easy serviceability.
The library SCSI interface-to-host system supports Low Voltage Differential (LVD). The tape drives and
the robotics control functions each use separate SCSI connections and SCSI ID addresses. Library
SCSI I/O is provided through two VHDCI-series, 68-pin, Micro-D SCSI connectors located at the
rear of the unit on each tape drive. Robotics SCSI I/O is provided through two VHDCI-series,
68-pin, Micro-D SCSI connectors located on the library controller board.
The remainder of this chapter describes the major components of the library, including:
• Models , page 15
• Accessories , page 16
• Tape Drives , page 16
• Magazines , page 21
• Power Supplies , page 22
• Robotics , page 23
• Library Controller Board , page 23
• Factory-Defined Accessory PCI Slots , page 25
• Front Panel Indicators , page 26
• Multi Unit Library Systems , page 27
Models
The MSL Series tape library family includes the following models:
• Two-drive models:
• MSL6030
• MSL6026
• Four-drive models:
• MSL6060
• MSL6052
NOTE: MSL6030/MSL6060 libraries operate with Ultrium LTO drive technology;
MSL6026/MSL6052 libraries operate with SDLT drive technology.