Furuno GP-150-DUAL - Manual (Page 14)

1. OPERATIONAL OVERVIEW
1-6
Data display
Refer to Chapter 6 for user-defined window
setting. The ZOOM icon can be displayed by
pressing the CURSOR ON/OFF key.
JAN 12, 2006 23:59'59" U
12
°
23.456' N
123
°
23.456' E
POSITION
RNG
31.23
nm
SOG
12.3
kt
BRG
223.4
°
COG
123.4
°
TO : 001
MARINE
POINT1
NEXT
: 002
MARINE
POINT2
Position in latitude and
U: UTC
J: JST
S: Ship's time
longitude or LOPs
Fixing date and time*
User-defined
display window
User-defined
display data #1 User-defined
display data #4
User-defined
display data #3 User-defined
display data #2
Current destination waypoint
Next destination waypoint
WGS84
D3D 100m
SAFE
Zoom icon
Figure 1-11 Data display mode
*: "--" appears until position is found. If fixing
error occurs the time indication freezes.
1.5 Transmitting Data
The GPS navigators share the data listed
below when transmitting data to each other.
Any action initiated against those data is
automatically repeated on the other navigator.
For example, if you register waypoint 27 on
one navigator it will be registered on the other
navigator under the same waypoint number.
• Alarm settings, alarm buzzer
• Destination data
• Disabled satellite data
• Error messages
• MOB/Event mark data
• Route data
• Waypoint data
Note:
This operation is necessary after
receiving waypoint data through the
DATA 4 port (Page 10-14).
Transmitting data
To mutually transmit data, do the following:
1) Press the MENU ESC key to display the
MAIN menu.
MAIN MENU
1. DISPLAY SETUP
2. TRACK/MARK SETUP
3. ERASE TRACK/MARK
4. ALARM SETTINGS
5. MANUAL CALCULATION
6.
7. GPS MONITOR
8. SELF TESTS
9. SYSTEM SETTINGS 1. DISPLAY SETUP
ENT: Enter MENU: Escape
Figure 1-12 MAIN menu
2) Press the 9 key to display the SYSTEM
SETTINGS menu.
SYSTEM SETTINGS
1. PLOTTER SETUP
3. DATA 1, 3 OUTPUT SETUP
4. DATA TRANSFER
5. DATA 4 I/O SETUP
6. GPS SETUP
7. DGPS SETUP
8. LOP SETUP
9. CLEAR MEMORY
2. UNIT SETUP
ENT: Enter MENU: Escape
Figure 1-13 SYSTEM SETTINGS menu
3) Press the 4 key to select DATA
TRANSFER.
DATA TRANSFER
Transmit Data
All Stop Start
: Select
ENT: Enter MENU: Escape
Figure 1-14 DATA TRANSFER menu