Furuno GP-150-DUAL - Manual (Page 54)

8. MENU SETTINGS
8-4
Time difference
1) Press MENU ESC, 9 and 6.
2) Press or to select Time Diff on
page 2/2.
3) Key in time difference (-14:00 to +14:00).
4) Press to change from plus to minus
or vice versa.
5) Press the MENU ESC key.
Position
After the unit is installed you may enter
position to shorten the time it takes to find
position. (It takes about two minutes when
there is no position data entered.)
1) Press
MENU ESC, 9 and 6.
2) Press or to select Posn on page
2/2.
3) If necessary, press to switch from
north latitude to south latitude or vice
versa. Key in latitude.
4) If necessary, press to switch from
east longitude to west longitude or vice
versa. Key in longitude.
5) Press the NU/CU ENT key.
6) Press the MENU ESC key.
8.2 Units of Measurement
Unit of distance
Distance can be displayed in nautical mile,
kilometer or statute mile as follows.
1) Press
MENU ESC, 9 and 2. The UNIT
SETUP menu appears.
Unit of Depth
Unit of Temp.
Unit of Altitude
UNIT SETUP
MENU : Escape
:Select
° C ° F
km sm
m ft FA
m ft
ENT : Enter
Unit of Distance nm
Figure 8-3 UNIT SETUP menu
2) Press to select Unit of Distance.
3) Press or to select unit; nm, km or
sm.
4) Press the NU/CU ENT key.
5) Press the MENU ESC key.
Unit of depth
1) Press MENU ESC, 9 and 2.
2) Press or to select Unit of Depth.
3) Press or to select unit; meter, feet,
or fathom.
4) Press the NU/CU ENT key.
5) Press the MENU ESC key.
Unit of water temperature
1) Press MENU ESC, 9 and 2.
2) Press or to select Unit of Temp.
3) Press or to select unit; Centigrade
or Fahrenheit.
4) Press NU/CU ENT and MENU ESC.
Unit of altitude
Available only in 3D mode.
1) Press
MENU ESC, 9 and 2.
2) Press or to select Unit of Altitude.
3) Press or to select unit.
4) Press the
NU/CU ENT key.
5) Press the MENU ESC key.