Furuno GP-150-DUAL - Manual (Page 28)

4. NAVIGATION PLANNING
4-2
6) Press to select waypoint mark shape.
The following display appears.
: Cursor
ENT: Enter MENU: Escape
Figure 4-4 Screen for selecting
waypoint mark shape
7) Press or to select mark shape.
8) Press the
NU/CU ENT key. The display
shown in Figure 4-5 appears.
ENT: Set MENU: Escape
ABCDE FGHIJ KLMNO PQRST UVWXYZ
abcde
: Cursor
A
fghij klmno pqrst uvwxyz
ENTER
COMMENT:
1 2 3 4 5 6 7 8 9 0 _ # % ’ ( ) + - . / : ; < = > ?
_ _ _ _ _ _ _ _ _ _ _ _
Figure 4-5 Screen for entry
of comment for waypoint
9) You may enter a comment, using up to
12 alphanumeric characters.
1
Press the cursor pad to select
alphanumeric character.
2
Press the NU/CU ENT key. Selected
character appears on the COMMENT
line.
• To create a space, select "_".
• Numeric data can be input directly by
pressing numeric keys.
• To clear wrong data, press the CLEAR
key.
3
Repeat steps 1 and 2 to complete
the comment.
4
Select ENTER and press the NU/CU
ENT key.
10) Press the
NU/CU ENT key.
Control is returned to the last-used display
mode.
When the waypoint number entered at step 5
already exists, the message shown in Figure
4-4 appears if the waypoint is part of the
current destination or route or is part of a
route. If you want to write over the waypoint
and its data, press the
NU/CU ENT key. To
change waypoint number, press the MENU
ESC key.
This wpt is GOTO
This wpt is in registered route
This wpt is in selected route
1st line
Are you sure to change ?
ENT: Yes MENU: No
Figure 4-6
Note: If you fail to enter waypoint number,
"Enter waypoint number" appears on
the display for three seconds.