Furuno GP-150-DUAL - Manual (Page 36)

5. SETTING DESTINATION
5-2
Flag
mark
Figure 5-4 Single destination set by cursor
Setting multiple destinations
1) Press GOTO and 1.
2) Place the cursor on the location desired
for a waypoint.
3) Press the NU/CU ENT key.
4) Repeat steps 2 and 3 to enter other points.
Waypoints are connected with a line.
5) Press the NU/CU ENT key to finish. The
route number entry display appears as
shown in Figure 5-5. If no route number
appears or you want to change the route
number shown, go to step 6 to enter route
number. To register the route under the
number shown, go to step 8.
Note: For the simple route, press the CLEAR
key and then go to step 8. The simple
route is not registered in the route list.
Enter route number
ENT:Enter MENU: Escape
0 1
Figure 5-5
6) Key in route number.
7) Press the
NU/CU ENT key. Waypoints are
marked with flags and are connected with
a dashed line.
If the route number entered already exists the
message shown in Figure 5-6 appears.
Overwriting ?
ENT:Yes MENU:No
Figure 5-6
8) Press the
NU/CU ENT key.
The waypoints do not have waypoint numbers,
however you can attach waypoint numbers by
doing the following.
1
Press WPT RTE and 5 to display the route
list.
2
Press or to select route number
entered.
3
Press .
4
Enter waypoint number, in three digits.
5
Press . If the waypoint number already
exists the message shown in Figure 5-7
appears.
This waypoint already exists
Are you sure to change ?
ENT:Yes MENU:No
Figure 5-7
6
Press the NU/CU ENT key. The waypoint
entered here replaces previously entered
waypoint.
Note: To cancel replacement of
waypoint, press the MENU ESC
key at step
6
.
7
Repeat steps
4
and
5
to enter other
waypoint numbers.
8
Press the MENU ESC key twice to finish.
When destination is cancelled, dashed lines
are erased but flags remain on the screen.