Furuno GP-150-DUAL - Manual (Page 59)

8. MENU SETTINGS
8-9
Stopping loading of data
1) Press the MENU ESC key. The message
shown in Figure 8-16 appears.
Are you sure to stop ?
ENT: Yes MENU:No
Figure 8-16
2) To quit loading, press the
NU/CU ENT
key. The cursor shifts to Stop.
3) To start loading, select Start.
4) Press the
NU/CU ENT key.
Loading waypoint data from YEOMAN
equipment
1) Do steps 1 through 9 in "Loading
Waypoint/route data."
2) Press or to select WPT.
3) Press to select Command.
4) Press to select Start. The message
shown in Figure 8-17 appears.
Are you sure to load ?
ENT: Yes MENU:No
Figure 8-17
5) Press the
NU/CU ENT key. The message
shown in Figure 8-18 appears.
Now loading
Waypoint data !
MENU:Stop
Figure 8-18
6) Operate the YEOMAN to output data.
When data is loaded, the cursor automatically
shifts to "Stop". Waypoints are loaded into
empty areas. When the waypoint area
becomes full, the message shown in Figure
8-19 appears.
Waypoint area is full !
Can’t load any data
Press any key to stop
Figure 8-19
7) When the data is loaded, press CU/NU
ENT and MENU ESC. The message
shown in Figure 8-20 appears.
The number of valid and invalid waypoints
appear in the message.
Loading completed
Valid waypoint : 0
Invalid waypoint : 0
Press any key
Figure 8-20
8) Press the MENU ESC key twice.
Saving data to personal computer
Waypoint and route data can be saved to a
personal computer.
1) Press
MENU ESC, 9 and 5.
2) Press to select Level.
3) Press or to select level; RS232C
or RS422.
4) Press the NU/CU ENT key. "Data"
appears in reverse video.
5) Press to select Com.
6) Press to select Next Page.
7) Press to select Baud Rate.
8) Press or to select baud rate;
4800bps, 9600bps, or 19200bps.
9) Press to select Command (under the
Save Data line). Stop, on the same line
as Command, appears in reverse video.
10) Press to select Start. The message
shown in Figure 8-21 appears.
Are you sure to save ?
ENT: Yes MENU:No
Figure 8-21