Multi-Tech Systems MULTIVOIP MVP-410ST/810ST - Manual (Page 129)

MultiVOIP User Guide Technical Configuration (T1/E1)
129
Local Configuration Procedure (Detailed)
You can begin the configuration process as a continuation of the
MultiVOIP software installation. You can establish your configuration
or modify it at any time by launching the MultiVOIP program from the
Windows Start menu.
1. Check Power and Cabling. Be sure the MultiVOIP is turned on and
connected to the computer via the MultiVOIP’s Command Port (DB9
connector at computer’s COM port; RJ45 connector at MultiVOIP).
You must allow the MultiVOIP to finish booting before you launch
the MultiVOIP Configuration Program. The RED boot LED turns
itself off when the booting process is completed.
2. Start MultiVOIP Configuration Program. Launch the MultiVOIP
program from the Windows Start menu (from the folder location
determined during installation).