Multi-Tech Systems MULTIVOIP MVP-410ST/810ST - Manual (Page 320)

T1 Phonebook Configuration MultiVOIP User Guide
320
PhoneBook Configuration Parameter Definitions
(cont’d)
Field Name Values Description
Single Port Protocol (SPP)
[continued]
Client Options Client Option fields are active
only in registrar/client mode
and only for client voip units.
Registrar IP
Address This is the IP address of the
registrar voip to which this
client is assigned. (Default
value = 0.0.0.0; effectively,
there is no useful default
value.)
Registrar
Port This is the port number of the
registrar voip to which this
client is assigned. (Default port
number = 10000.)
Registrar Options Registrar Option fields are
active only in registrar/client
mode and only for registrar
voip units.
Keep Alive
(in sec.) Time-out duration before a
registrar will unregister a
client that does not send its
“I’m here” signal. Client
normally sends its “I’m here”
signal every 20 seconds.
Timeout default = 60 seconds.
Proxy/NAT Device
Parameters
Behind
Proxy/NAT
device Y/N Enables MultiVOIP (running
in SPP Registrar mode) to
operate ‘behind’ a proxy/NAT
device (NAT = Network
Address Translation).
Proxy/NAT
Device
Parameters –
Public IP
Address n.n.n.n
where
n=0-255 The public IP address of the
proxy/NAT device which the
MultiVOIP is behind.