Multi-Tech Systems MULTIVOIP MVP-410ST/810ST - Manual (Page 207)

MultiVOIP User Guide Technical Configuration (Analog/BRI)
207
Configuring the Analog/BRI MultiVOIP
There are two ways in which the MultiVOIP must be configured before
operation: technical configuration and phonebook configuration.
Technical Configuration . First, the MultiVOIP must be configured to
operate with technical parameter settings that will match the
equipment with which it interfaces. There are eight types of technical
parameters that must be set.
These technical parameters pertain to
(1) its operation in an IP network,
(2) its operation with telephony equipment,
(3) its transmission of voice and fax messages,
(4) its interaction with SNMP (Simple Network Management Protocol)
network management software (MultiVoipManager),
(5) certain telephony attributes that are common to particular nations or
regions,
(6) its operation with a mail server on the same IP network (per SMTP
parameters) such that log reports about VoIP telephone call traffic can
be sent to the administrator by email,
(7) implementing some common premium telephony features (Call
Transfer, Call Hold, Call Waiting, Call ID – “Supplementary Services”),
and
(8) selecting the method by which log reports will be made accessible.
The process of specifying values for the various parameters in these
seven categories is what we call “technical configuration” and it is
described in this chapter.
Phonebook Configuration . The second type of configuration that is
required for the MultiVOIP pertains to the phone number dialing
sequences that it will receive and transmit when handling calls. Dialing
patterns will be affected by both the PBX/telephony equipment and the
other VOIP devices that the MultiVOIP unit interacts with. We call this
“Phonebook Configuration,” and, for analog MultiVOIP units, it is
described nominally in Chapter 9: Analog Phonebook Configuration of this
manual. But, in fact, nearly all of the descriptions and examples for
analog phonebook configuration are to be found in Chapter 7 if the
analog voip is operating under the North American telephony scheme,
or in Chapter 8 if the analog voip is operating under a European
telephony scheme. Chapter 2, the Quick Start Instructions, presents
additional examples relevant to the analog voips.