Multi-Tech Systems MULTIVOIP MVP-410ST/810ST - Manual (Page 33)

MultiVOIP User Guide Overview
33
MVP-130/130FXS Front Panel LED Definitions
LED NAME DESCRIPTION
General Operation LEDs
Power Indicates presence of power.
Boot After power up, the Boot LED will be on briefly while
the MultiVOIP is booting. It lights whenever the
MultiVOIP is booting or downloading a setup
configuration data set.
Ethernet
FDX. LED indicates whether Ethernet connection is
half-duplex or full-duplex (FDX) and, in half-duplex
mode, indicates occurrence of data collisions. LED is
on constantly for full-duplex mode; LED is off
constantly for half-duplex mode. When operating in
half-duplex mode, the LED will flash during data
collisions.
LNK.
Link/Activity LED. This LED is lit if Ethernet
connection has been made. It is off when the link is
down (i.e., when no Ethernet connection exists).
While link is up, this LED will flash off to indicate data
activity.
Channel-Operation LEDs
TX Transmit . This indicator blinks when voice packets
are being transmitted to the local area network.
RX Receive . This indicator blinks when voice packets
are being received from the local area network.
XS
Transmit Signal. This indicator lights when the
FXS-configured channel is off-hook or the FXO-
configured channel (MVP130 only) is receiving a ring
from the Telco or PBX.
RS Receive Signal
. This indicator lights when the FXS-
configured channel is ringing or the FXO-configured
channel (MVP130 only) has taken the line off-hook.