Multi-Tech Systems MULTIVOIP MVP-410ST/810ST - Manual (Page 92)

Mechanical Installation & Cabling MultiVOIP User Guide
92
19-Inch Rack Enclosure Mounting Procedure
Attaching the MultiVOIP to a rack-rail of an EIA 19-inch rack enclosure
will certainly require two persons. Essentially, the technicians must
attach the brackets to the MultiVOIP chassis with the screws provided,
as shown in Figure 3-6, and then secure unit to rack rails by the
brackets, as shown in Figure 3-7. Because equipment racks vary, screws
for rack-rail mounting are not provided. Follow the instructions of the
rack manufacturer and use screws that fit.
1. Position the right rack-mounting bracket on the MultiVOIP
using the two vertical mounting screw holes.
2. Secure the bracket to the MultiVOIP using the two screws
provided.
3. Position the left rack-mounting bracket on the MultiVOIP
using the two vertical mounting screw holes.
4. Secure the bracket to the MultiVOIP using the two screws
provided.
5. Remove feet (4) from the MultiVOIP unit.
6. Mount the MultiVOIP in the rack enclosure per the rack
manufacture’s mounting procedure.
x
x
Figure 3-6: Bracket Attachment for Rack Mounting
(MVP-2410/3010 & MVP-410/810)
Figure 3-7: Attaching MultiVOIP to Rack Rail
(MVP-2410/3010 & MVP-410/810)