Multi-Tech Systems MULTIVOIP MVP-410ST/810ST - Manual (Page 212)

Technical Configuration (Analog/BRI) MultiVOIP User Guide
212
ISDN-BRI Telephony Parameters
(for MVP-410ST/810ST)
The following parameters must be known about the PBX or telco
central office equipment to which the analog MultiVOIP will connect:
9 ISDN-BRI Phone Parameters
Ask phone company or
telecom manager.
Needed for:
MVP810ST
MVP410ST
ISDN-BRI Telephony Interface Parameters:
Record them for this VOIP Site
#
• In which country is this voip installed?
• Which operator (switch type) is used?
• What type of line coding use required,
A-law or u-law?
• Determine which BRI ports will be network side and
which BRI ports will be terminal side.
Write down the values for these telephony parameters (whether analog
or ISDN-BRI). You will need to enter these values in the “Interface”
screen (analog) or “ISDN Parameters” screen (ISDN-BRI) in the
Configuration section of the MultiVOIP software.