Multi-Tech Systems MULTIVOIP MVP-410ST/810ST - Manual (Page 246)

Technical Configuration (Analog/BRI) MultiVOIP User Guide
246
FXS Loop Start Interface: Parameter Definitions (cont’d)
Field Name Values Description
Caller ID fields
Caller ID
enable (cont’d) Y/N The forms of the ‘Caller Name’
and ‘Caller Phone Number’
differ depending on the IP
transmission protocol used
(H.323, SIP, or SPP) and upon
entries in the phonebook
screens of the remote (CID
generating) voip unit. The CID
Name and Number appearing
on the phone at the terminating
FXS end will come either from a
central office switch (showing a
PSTN phone number), or the
phonebook of the remote (CID
sending) voip unit.
The Caller ID feature has dependencies on both the telco central office
and the MultiVOIP phone book. See the diagram series after the FXO
Parameters section below.