Multi-Tech Systems MULTIVOIP MVP-410ST/810ST - Manual (Page 169)

MultiVOIP User Guide Technical Configuration (T1/E1)
169
The SNMP Parameter fields are described in the table below.
SNMP Parameter Definitions
Field Name Values Description
Enable SNMP
Agent Y/N Enables the SNMP code in the
firmware of the
MultiVOIP . This
must be enabled for the MultiVOIP
to communicate with and be
controllable by the
MultiVoipManager software.
Default: disabled
Trap Manager Parameters
Address 4 places; n.n.n.n
n = 0-255 IP address of MultiVoipManager
PC.
Community
Name -- A “community” is a group of VOIP
endpoints that can communicate
with each other. Often “public” is
used to designate a grouping where
all end users have access to entire
VOIP network. However, calling
permissions can be configured to
restrict access as needed.
Port Number 162 The default port number of the
SNMP manager receiving the traps
is the standard port 162.
Community
Name 1 Length = 19
characters (max.)
Case sensitive. First community grouping.
Permissions Read-Only,
Read/Write
If this community needs to change
MultiVOIP settings, select
Read/Write. Otherwise, select
Read-Only to view settings.
Community
Name 2 Length = 19
characters (max.)
Case sensitive. Second community grouping
Permissions Read-Only,
Read/Write
If this community needs to change
MultiVOIP settings, select
Read/Write. Otherwise, select
Read-Only to view settings.