McDATA 4300 - Manual (Page 100)

3-36 McDATA Sphereon 4300 Fabric Switch Installation and Service Manual
Maintenence Analysis Procedures
• Event code 142 - OpenTrunking firmware detected an ISL with
no transmission BB_Credit for a period of time that exceeded the
configured low BB_Credit threshold. This results in downstream
fabric congestion.
No action is required for an isolated event or if the reporting ISL
approaches 100% throughput. If the event persists, perform one of
the following:
• Relieve the congestion by adding parallel ISLs between the
fabric elements reporting the problem.
• Increase the ISL link speed between the fabric elements
reporting the problem (from 1 Gbps to 2 Gbps).
• Reroute Fibre Channel traffic by moving device connections to a
less-congested region of the fabric.
Was the maintenance action successful?
NO YES
↓
The fabric, ISL, and product are operational. Exit MAP.
Contact the next level of support. Exit MAP.
22
Event code 150 indicates a fabric merge process failed during ISL
initialization. An incompatible zone set was detected or a problem
occurred during delivery of a zone merge frame. This event code
always precedes event code 070, and represents the reply of an
adjacent fabric element in response to a zone merge frame. Obtain
supplementary event data as follows:
a. At the Event Log, examine the first 12 bytes (0 through 11) of
event data.
b. Bytes 0 specifies the E_Port reporting the problem. Bytes 8
through 11 specify the failure reason as listed in Table 3-14 .
Table 3-14 Fabric Merge Failure Reasons and Actions
Bytes 8 - 11 Merge Failure Reason Action
01 Invalid data length. Go to step 23 .
08 Invalid zone set format. Go to step 23 .
09 Invalid data. Go to step 24 .
0A Cannot merge. Go to step 24 .