McDATA 4300 - Manual (Page 96)

3-32 McDATA Sphereon 4300 Fabric Switch Installation and Service Manual
Maintenence Analysis Procedures
b. At the EFCM Basic Edition interface, inspect names in the active
zone set to determine the incompatible zone name, then modify
the name as directed by the customer. Refer to the McDATA
EFCM Basic Edition User Manual (620-000240) for instructions.
Was the maintenance action successful?
NO YES
↓
The fabric, ISL, and product are operational. Exit MAP.
Contact the next level of support. Exit MAP.
11
An E_Port segmented because a build fabric protocol error was
detected.
a. Disconnect the fiber-optic jumper cable from the segmented
E_Port.
b. Reconnect the cable to the same port.
Was the maintenance action successful?
NO YES
↓ The fabric, ISL, and product are operational. Exit MAP.
12
Reset the product. Refer to IML or Reset Switch for instructions.
Was the maintenance action successful?
NO YES
↓
The fabric, ISL, and product are operational. Exit MAP.
Perform a data collection and contact the next level of support. Refer
to
Collect Maintenance Data . Exit MAP.
13
An E_Port segmented because no product in the fabric is capable of
becoming the principal switch.
a. Inform the customer the product will be set offline. Ensure the
system administrator quiesces Fibre Channel frame traffic and
sets attached devices offline.
b. Set the product offline. Refer to Set Online State .
c. Select Switch and Fabric Parameters from the Configure menu
at any view. The Fabric Parameters View displays.