Samsung S3F80JB - Manual (Page 333)

DEVELOPMENT TOOLS DATA S3F80JB
20-4
Table 20-2. Default Setting of the Jumper in S3F80JB Target Board
JP# Description 1-2 connection 2-3 connection Setting
S1 Target board power source Open-ice power Join 1-2
JP1 Target board mode selection H: Main-Mode L: EVA-Mode Join 2-3
JP2 Operation Mode H: User Mode L: Test-Mode Join 1-2
JP3 MDS version SMDS2 SMDS2+ Join 2-3
JP5 Board peripheral power
connection
Board peripheral power connection Connect
JP6 When supplied 5V in target
board, generation of 3.3V
using regulator. In case of selection 3.3V
between open-ice powers,
connect core without a step
of regulation. In case of selection 5V
between open-ice powers,
connect regulator to
generate 3.3V Join 2-3
JP8 80JB V
DD
power connection 80JB V
DD
power connection Connect
JP10 Clock source selection When using the internal clock source which is generated
from OPENice-i500, join connector 2-3 and 4-5 pin. If
user wants to use the external clock source like a crystal,
user should change the jumper setting from 1-2 to 5-6
and connect Y1 to an external clock source.
JP11 Regulator 3.3 Volt-Out
connection
Connection between regulator out voltage and 80JB’s
Power V
DD
when using the regulator. When debugging
with Openice-i500, JP11 don’t need to be connect.
SW2 Smart option at address 3EH Dip switch for smart option. These 1byte are mapped
address 3EH for special function. Refer to the page 2-3.
SW3 Smart option at address 3FH Dip switch for smart option. These 1byte are mapped
address 3FH for special function. Refer to the page 2-3.
Y1 External clock source Connecting point for external clock source like a crystal.
J3 Header for flash serial
programming signals To program an internal flash, connect the signals with
flash writer tool. J3
To
User_Vcc
Target System is supplied
V
DD
Target Board is not supplied
V
DD
to Target System.
Target Board is supplied
V
DD
to Target System.
Join 2-3
NOTE: S3F80JB Target board consists of 74HC11N, regulator and other components. In case of 74HC11N, typical
operating voltage is 5V. So 80jb target board includes a regulator for 3.3V generation. As you know, S3F80JB typical
operating voltage is 3.3V. Although open-i500 supports 3.3 V for target board ‘s power source, we recommend that
you connect jumper of open-i500 power source to 5V. Check the interface board’s jumper status between emulator
and target board.
– nRESET LED
This LED is OFF when the Reset switch is ON.
– IDLE LED
This is LED is ON when the evaluation chip (S3E80JB) is in idle mode.
– STOP LED
This LED is ON when the evalution chip (S3E80JB) is in stop mode.