Seiko Instruments SII Black-and-White Raster Plotter LP-1020 - Manual (Page 127)

5-9
▼Setting parameter items
Chapter 5 "SETUP" Menu
(F)
Third hierarchy item Parameter Remarks
PEN PAR. MODE
DATA PRIORITY
PANEL PRIORITY
PEN N WIDTH (mm)
0.00 to 16.00
(Initial value)
PEN 0 : 0.2
PEN 1 : 0.3
PEN 2 : 0.4
PEN 3 : 0.5
PEN 4 : 0.6
PEN 5 : 0.7
PEN 6 : 0.8
PEN 7 : 0.9
PEN 8 and later : 1.0
Pen 8 and later: 10
Set HP-GL to pen 0 to 15.
0.00 is 1-dot width.
Set DSCAN to pen 1 to 32.
PEN N WIDTH (in)
0 to 0.629 inches
(Initial value)
PEN 0 : 0.008 inches
PEN 1 : 0.012 inches
PEN 2 : 0.016 inches
PEN 3 : 0.020 inches
PEN 4 : 0.024 inches
PEN 5 : 0.028 inches
PEN 6 : 0.031 inches
PEN 7 : 0.035 inches
PEN 8 and later: 0.039 inches
Pen 8 and later: 10
Set HP-GL to pen 0 to 15.
0.00 is 1-dot width.
Set DSCAN to pen 1 to 32.
PEN DENSITY (%)
0 to 100 (Initial value)
Pen 0 : 0
Pen 1 and later : 100
Set HP-GL to pen 0 to 15.
Set DSCAN to pen 1 to 32.
PEN N CORNER
ROUND
BUTT Set HP-GL to pen 0 to 15.
Set DSCAN to pen 1 to 32.
PEN N JOINT
ROUND
MITERED Set HP-GL to pen 0 to 15.
Set DSCAN to pen 1 to 32.
PEN ADJUST (mm)
-0.99 to +0.99
(Initial value = 0.00)
PEN ADJUST (in)
-0.038 to +0.038 inches
(Initial value = 0.00)
LINE DISPOSAL
OFF
ON