Seiko Instruments SII Black-and-White Raster Plotter LP-1020 - Manual (Page 233)

14-17
▼When an error message appears
Chapter 14 Troubleshooting
Warning
■Operator notice warning
Description : The saved job has been damaged, and thus the spool area
is initialized (When HDD is installed).
Measure : After 3 seconds, the message changes to “WAIT A
MOMENT” and then the device starts.
Description : The received data is in a format not supported by the
device, and thus the data was ignored.
Measure : Use the data in a format supported by the device.
Description : The spool area on the HDD has been damaged, and thus
the memory spool area is used (When HDD is installed).
Measure : If the device does not recover from this error when you
turn the power off and on, please notify your dealer or
our service center of the displayed error message and
error condition.
W S P O O L I N I T I A L I Z E D
J O B W A S D E L E T E D
W J O B W A S D E L E T E D
W S P O O L E R R O R