Seiko Instruments SII Black-and-White Raster Plotter LP-1020 - Manual (Page 236)

14-20
■Communication warnings
Description : A communication error message appears if any
communication error occurs between the computer and the
device. For a practical description, see the following table.
Measure : If the device does not recover from this error by turning
the power off and on, follow the guidelines described in
the Measure column of the table. If the error is not
removed, please notify your dealer or our service center
of the displayed error message and error condition.
(1) Ethernet interface
W I N T E R F A C E - L N x x x x
◆ A communication warning appears on the LCD, but it
disappears when the next operation is performed.
Consequently, you may not recognize that the error
occurred. In such a case, retransmit the data to check if
the communication warning is displayed on the LCD.
Note
xxxx: Error code
Error code Description Measure
0101
Duplication of XPT port
number
Specify the parameter at the device side correctly.
0212 Lack of internal memory
If the device does not recover from this error by
turning the power off and on, take the following
measures:
- Check if the communication condition and
protocol match the specifications of the computer.
- Check if the connection cable is defective or
is connected securely.
- If the error is not removed, please notify your
dealer or our service center of the displayed error
message and error condition.
0220 to 022F
Protocol data sent from the
host is defective
0250 to 025F
Host disconnects the
communication forcibly
while a connection is
established
0260 to 026F
Communication to the host
failed while communication
time out data is transferred
1000 to 4FFF
Communication connection
system error
5000 to 7FFF
Communication system
internal error