Seiko Instruments SII Black-and-White Raster Plotter LP-1020 - Manual (Page 60)

2-18
6
Close the paper roll drawer.
Gently push in the Roll 1 or Roll 2 drawer.
When the paper roll drawer is closed, the following
message appears.
After the replacement, the device will return to the
status before the paper roll was replaced.
Note
Note
W A I T A M O M E N T
(It will take about 30 seconds until paper feeding is ready.)
◆After closing the paper roll drawer, wait until the “WAIT A
MOMENT” message disappears before opening the paper
roll drawer again. As the device initiates a paper detection
just after the paper roll drawer is closed, so opening the
paper roll drawer during this operation may cause a paper
jam.
◆If you change the type of paper roll, you must change the
corresponding settings, referring to “Paper settings” (⇒
page 7-2).