Seiko Instruments SII Black-and-White Raster Plotter LP-1020 - Manual (Page 58)

2-16
How to attach the paper roll
◆ The paper flange ends do not have a designated right or left
side. You can attach them to either side.
1
Attach the paper flange to a paper roll.
Push in the paper flange ends until they contact the
paper roll tube, then secure the flange ends by
turning the knob in the “CLOSE” direction.
2
Move the flange guide.
the label which is affixed to the inside of the drawer
indicates the flange positions for the application of
different roll widths. Move the flange guide to
match the paper roll size you are using.
3
Load the paper roll into the drawer.
Hold the paper roll so that the end of the paper is
positioned at the bottom facing the back of the
device. Then align the paper flange to the
depressions in the flange guide and gently insert the
flange in place.
C L O S
E
O PE N
Knob
Note
Note
Flange guide
◆If the paper flange knobs are loosely
fitted, the paper roll will move adversely
to the right and left and negatively affect
the drawing. Make sure that the knobs
are tightened securely.
◆Take care not to drop the paper roll
while performing these activities.
Label
C L O S
E
O PE N