Seiko Instruments SII Black-and-White Raster Plotter LP-1020 - Manual (Page 84)

2-42
Web function startup method
1
The following preparations must be made from the plotter
side.
1 Turn on the plotter power.
2 Confirm the IP address setting. (If this setting has not yet been set, set this
setting according to the instructions which appears when the device is
booted).
3 Set each Ethernet parameter where necessary.
2
Launch the Web browser.
1 Obtain the Web browser for the host computer.
• Microsoft Internet Explorer Ver11.5 and later
• Netscape Communicator Ver5.0 and later
2 Launch the Web browser.
3 Enter “http:// the IP address set to the device/” into the address column
and press the Enter key.