Seiko Instruments SII Black-and-White Raster Plotter LP-1020 - Manual (Page 59)

2-17
▼Replacing paper rolls
Chapter 2 Basic operations
Caution
4
Insert the end of the paper roll into the paper feed inlet of
the device.
Turn the paper flange and insert the end of the
paper roll so that it is straight. Turn the paper
feed knob so that the end of the paper roll
projects about 10 cm.
5
Cut the end of the paper.
While holding the end of the paper roll, cut it off
with the cutter.
The “Paper cutter position” label is affixed to
both ends of the space where the cutter blade
should be inserted. Insert the cutter blade into
the space where the label arrow is pointing.
Slide the cutter blade along the space and cut the
paper.
◆ The paper can be cut cleanly when the
cutter is inserted in a perfectly sideways
direction.
Paper feed knob
◆Take care not to hurt yourself and damage the device when
handling the cutter.
◆Handle the cutter blade with care so that you do not break it.
◆When sliding the cutter along the space, take care not to cut
the back of your hand on the sides of the paper tray.