Right side/rear side – Seiko Instruments SII Black-and-White Raster Plotter LP-1020 User Manual
Page 36
1-12
Right side/rear side
1
Main power switch
Turns the device power on and off. (⇒ page 2-3)
2
Power cord
Plug this cord into a power cord socket.
3
Parallel interface connector
This is an interface connector conforming to the standards of the
Parallel interface connector of Centronix.
4
Ethernet interface connector
This is an interface connector for a 100 BASE-TX and 10 BASE-T
Ethernet interface connector.
5
USB interface connector This is an interface connector for a USB 2.0 interface connector.
6
Cutter door (door 5)
Open this door to deal with paper jams at the cutter area.
(⇒ page 14-3)
7
Cutter door inside (door 9)
Open this door to deal with paper jams at the cutter area.
(⇒ page 14-3)
8
Cutter door lower small door (door 10)
Open this door to deal with paper jams at the cutter area.