Seiko Instruments SII Black-and-White Raster Plotter LP-1020 - Manual (Page 149)

5-31
▼Setting parameter items
Chapter 5 "SETUP" Menu
• Line end shape of each parameter is illustrated below.
• Any combinations other than CORNER = "ROUND" and JOINT =
"ROUND" may take much time for plotting.
• The outermost line of the plot may not be treated for the line end
shape.
● PEN N JOINT
Allows for setting the line joint method of the pen of this device.
Setting is performed on the third hierarchy.
<Parameter (choice input method)> : Default value
ROUND Specifies the joint in the round form.
MITERED Specifies the joint in the mitered form.
ROUND BUTT
a
a = 1/2 of line width
■PEN N CORNER
Allows for setting of the line end shape of the pen of this device.
This setting is performed on the third hierarchy.
<Parameter (choice input method)> : Default value
ROUND Specifies the line end in a round shape.
BUTT Specifies the line end in a butt shape.