SEH Computertechnik TPG60 - Manual (Page 10)

General Information
TPG60 User Manual 10
Subnet Mask
With the help of the subnet mask, large networks can be split up
into subnetworks. In this case, the user IDs of the IP addresses are
assigned to the various subnetworks.
The TPG60 is configured not to use subnetworks by default. If you
wish to use a subnetwork, you can configure the relevant parameter
via the TPG Homepage or the InterCon-NetTool.
1.6 Safety Regulations
Before starting the initial operation procedure of the TPG60,
please note the safety regulations in the Quick Installation Guide.
1.7 First Steps
This section provides all the information that you need to operate
the TPG60.
Proceed as follows:
1. Connect the TPG60 to the network and the mains supply; see
Quick Installation Guide.
2. Make sure that an IP address is stored in the TPG60; see:
’Saving the IP Address in the TPG60’
Ö
11.
3. Define the ThinPrint® port, the bandwidth, and the printers to
which the TPG60 will send print jobs; see: ’ThinPrint® Settings’
Ö
48.
ª
The TPG60 is operational.