SEH Computertechnik TPG60 - Manual (Page 52)

ThinPrint® Settings
TPG60 User Manual 52
To use this service, you must prepare the TPG60. For each end device
that uses the Connection Service, you must store the client ID and
an authentication key in the database of the Connection Service.
You must also set these two values on the TPG60.
Please note that you need a ThinPrint® license for each client ID.
What do you want
to do?
†
’Configuring the Connection Service via the TPG Homepage’
Ö
52
†
’Configuring the Connection Service via the InterCon-NetTool’
Ö
52
Configuring the Connection Service via the TPG Homepage
Proceed as follows:
1. Start the TPG Homepage.
2. Select Configuration – ThinPrint®.
3. Tick Connection Service.
4. Enter the relevant data; see: table 5
Ö
53.
5. Click Save to confirm.
ª
The settings are saved.
Configuring the Connection Service via the InterCon-NetTool
Proceed as follows:
1. Start the InterCon-NetTool.
2. Double-click the TPG60 in the print server list.
The Properties dialog appears.
3. Select Configuration – ThinPrint® from the navigation bar.
4. Select the Connection Service tab.
5. Tick Connection Service.
6. Enter the relevant data; see: table 5
Ö
53.
7. Click OK to confirm.