SEH Computertechnik TPG60 - Manual (Page 53)

ThinPrint® Settings
TPG60 User Manual 53
ª
The settings are saved.
Table 5: Connection Service Parameter
If a connection to the Connection Service was refused, it is because
a value (client ID, authentication key, or IP address) was entered
incorrectly. Check and modify your settings and reestablish the
connection to the Connection Service manually. For this purpose,
click Reconnect.
6.5 How Does the TPG60 Receive Encrypted Data?
A secure connection during the transfer of print jobs between
ThinPrint® (server or Connection Service) and the TPG60 is
guaranteed by means of an SSL encryption.
Parameter Description
Connection Service Enables/disables the .print Connection Service
Connection Server IP address of the server on which the Connection
Service is installed.
Port Port number used by the TPG60 to communicate with
the Connection Service (default = 4001)
Client ID Client ID as stored in the database of the Connection
Service. The client ID is needed by the Connection
Service to forward print jobs to the TPG60.
Authentication key Authentication key as stored in the database of the
Connection Service.
Keep alive Interval (in seconds) for refreshing the connection to
the Connection Service.
The value has to be lower or equal than the
'KeepAliveTO' parameter of the .print Connection
Service (server side).
(allowed entry: 30 - 180 | default = 60)
Connection retry Interval (in seconds) for connection retries if the
Connection Service is not reachable.
(allowed entry: 5 -6000 | default = 120)