SEH Computertechnik TPG60 - Manual (Page 9)

General Information
TPG60 User Manual 9
TPG Default Name
The TPG name is made up of the two letters 'IC' and the device
number. The device number consists of the last six numbers of its
hardware address.
Fig. 2: Example: Default name
The TPG default name is found on the TPG Homepage, the
InterCon-NetTool, or the status page.
IP Address
The IP address is the unique address of each node in a network, i.e.
an IP address may occur only once on a local network. The system
administrator usually assigns the IP address. The address must be
saved in the TPG60 to make sure that it can be addressed within the
network.
Host Name
The host name is an alias for an IP address. The host name uniquely
identifies the TPG60 in the network and makes it easier to
remember.
Gateway
Using a gateway, you can address IP addresses from external
networks. If you wish to use a gateway, you can configure the
relevant parameter via the TPG Homepage or the InterCon-NetTool.
IC0001ff
Device
number
TPG Default Name