SEH Computertechnik TPG60 - Manual (Page 37)

Parameter
TPG60 User Manual 37
the parameters to their default settings to install the TPG60 in a
different network.
If the TPG60 is protected by a password, the password has to be
entered before resetting the parameters. Only by using the status
button on the operating panel of the TPG60 can the parameters be
reset without entering the password.
What do you want
to do?
†
’Resetting Parameters via the TPG Homepage’
Ö
37
†
’Resetting Parameters via the InterCon-NetTool’
Ö
37
†
’Resetting Parameters via an FTP Connection’
Ö
38
†
’Resetting Parameters via the TPG60 Status Button’
Ö
38
Resetting Parameters via the TPG Homepage
Proceed as follows:
1. Start the TPG Homepage.
2. Select Actions – Default Settings.
ª
The parameters are reset.
Resetting Parameters via the InterCon-NetTool
Proceed as follows:
1. Start the InterCon-NetTool.
2. Mark the TPG60 in the print server list.
3. Select Actions – Default Settings from the menu bar.
4. Click Finish.
ª
The parameters are reset.