SEH Computertechnik TPG60 - Manual (Page 12)

General Information
TPG60 User Manual 12
For this purpose, the TPG60 picks an IP address at random from the
address range 169.254.0.1 to 169.254.255.254 which is reserved for
ZeroConf and sends a query to the network. If this IP address has
already been assigned elsewhere in the network, the TPG60 will
receive a message. The TPG60 then sends another query with a
different IP address. If the IP address is available, it is saved in the
TPG60.
If you wish to use an IP address different from the one assigned via
ZeroConf, you can save a freely definable IP address in the TPG60
later on.
InterCon-NetTool (IP Wizard)
You can easily enter the desired IP address and save it in the TPG60
using the IIP Wizard of the InterCon-NetTool, see: ’Administration
via the InterCon-NetTool’
Ö
17.
The IP Wizard helps you to configure the TCP/IP parameters, e.g. the
IP address. You can choose between the manual configuration and
the automatic configuration via boot protocols.
Saving the IP address via the InterCon-NetTool in networks with
routers is only possible if the router forwards multicast requests and
if network devices are searched for via multicast.
Requirements
;
The TPG60 is connected to the network and the mains voltage.
;
The InterCon-NetTool is installed on your local system.
Proceed as follows:
1. Start the InterCon-NetTool.
2. Mark the TPG60 in the print server list.
The TPG60 is displayed in the print server list under 'ZeroConf'
with an IP address from the address range 169.254.0.1 through
169.254.255.254, which is reserved for ZeroConf.
3. Select Installation – IP Wizard from the menu bar.
4. Follow the instructions of the Wizard.
ª
The settings are saved.