Installation, Warning – Lincoln Electric POWER WAVE SVM173-A User Manual

Page 16

Advertising

DIP SWITCH SETTINGS AND LOCATIONS

DIP switches on the PC boards allow for custom con-
figuration of the Power Wave. Access the DIP switch-
es as follows:

ELECTRIC SHOCK CAN KILL.

• Do not touch electrically live parts or

electrodes with your skin or wet cloth-
ing.

• Insulate yourself from the work and

ground.

• Always wear dry insulating gloves.

• Turn off power at the disconnect switch.

• Remove the top four screws securing the front access

panel.

• Loosen, but do not completely remove, the bottom

two screws holding the access panel.

• Open the access panel, allowing the weight of the

panel to be carried by the bottom two screws. Make
sure to prevent the weight of the access panel from
hanging on the harness.

• Adjust the DIP switches as necessary. Using a pen-

cil or other small object, slide the switch left for the
ON position or to the right for the OFF position, as
appropriate.

• Replace the panel and screws and restore power.

CONTROL BOARD DIP SWITCH:

switch 1 = reserved for future use
switch 2 = reserved for future use
switch 3 = reserved for future use
switch 4 = reserved for future use
switch 5 = reserved for future use
switch 6 = reserved for future use
switch 7 = reserved for future use
switch 8 = work sense lead

switch 8

work sense lead

off

work sense lead not connected

work sense lead connected

FEED HEAD BOARD DIP SWITCH:

switch 7

electrode polarity

off

positive

negative

switch 8