Paradyne 3160 - Manual (Page 150)

Configuration Options
C-6 3160-A2-GB21-80 March 1999
Table C-2. Port Configuration Options (4 of 5)
EDL: Disab
Next Enab Disab Prev
Embedded Data Link. Specifies whether Embedded Data Link (EDL) is enabled for a
particular port. If EDL is enabled, then 8 kbps of the total bandwidth allocated for this
port is not available to the synchronous data port. For example, if the port rate is 256
kbps (4 DS0 channels allocated) and EDL is enabled, then only 248 kbps is available to
the port. EDL provides the following: detection of frame synchronization, CRC of the
data stream (excluding the 8 kbps EDL), and an in-band data link (4 kbps) between the
local and remote units. The 4 kbps in-band data link can be used for performance report
messages and as an IP link for SNMP or Telnet sessions.
Enab – Indicates the port’s EDL is enabled.
Disab – Indicates the port’s EDL is disabled.
NOTES: – This configuration option is only available on 2-port and 4-port
DSU/CSUs.
– If the local DSU/CSU’s EDL is enabled, then the remote DSU/CSU’s
EDL must also be enabled.
– EDL is not recommended for networks in which data is examined for
routing purposes (e.g., frame relay, x.25).
Err Rate: 10E-4
Next 10E-4 10E-5 10E-6 10E-7 10E-8 10E-9 Prev
Port Excessive Error Rate Threshold. Sets the error rate threshold that determines
when an Excessive Error Rate (EER) condition is declared for a particular port. The
error rate selected by this configuration option is determined by the ratio of the number
of CRC5 errors to the total number of bits received over a set period of time.
10E-4 – 10E-4 Threshold. For example, at 1536 kbps, EER is declared if more than
1,535 CRC5 errors are detected in a 10-second period. It is cleared with less than 1,536
errors in ten seconds.
10E-5 – 10E-5 Threshold. For example, at 1536 kbps, EER is declared if more than 921
CRC5 errors are detected in a 60-second period. It is cleared with less than 922 errors
in sixty seconds.
10E-6 – 10E-6 Threshold. For example, at 1536 kbps, EER is declared if more than 92
CRC5 errors are detected in a 60-second period.
It is cleared with less than 93 errors in
sixty seconds.
10E-7 – 10E-7 Threshold. For example, at 1536 kbps, EER is declared if more than 9
CRC5 errors are detected in a 60-second period. It is cleared with less than 10 errors in
sixty seconds.
10E-8 – 10E-8 Threshold. For example, at 1536 kbps, EER is declared if more than 41
CRC5 errors are detected in three 15-minute intervals. It is cleared with less than 42
errors in three 15-minute intervals.
10E-9 – 10E-9 Threshold. For example, at 1536 kbps, EER is declared if more than 4
CRC5 errors are detected in three 15-minute intervals. It is cleared with less than 5
errors in three 15-minute intervals.
NOTES: – This configuration option is only available on 2-port and 4-port
DSU/CSUs.
– This configuration option is not available if EDL is disabled.