Paradyne 3160 - Manual (Page 182)

Configuration Options
C-38 3160-A2-GB21-80 March 1999
Table C-10. Management Trap Configuration Options (1 of 3)
Num Trap Mgrs: 1
Next 1 2 3 4 5 6 Prev
Number of Trap Managers. Specifies the number of SNMP trap managers that are to
receive traps for this unit.
NOTE: You must configure an IP address for each trap manager that is to receive
trap messages.
Trap n IP Adr:
Next Edit Clear Prev
Trap n IP Address. Specifies the IP address for each trap manager. This configuration
option is repeated for all trap managers supported by the unit.
Edit – Allows you to edit or display the IP address for Trap Manager n.
Clear – Allows you to clear the IP address for Trap Manager n. The IP address is set to
000.000.000.000.
Trap n Dst: None
Next None IPBus Com Modem Aux FDL EDL1 EDL2 EDL3
EDL4 Prev
Trap Manager n Destination. Specifies the network destination for Trap Manager n. This
configuration option is displayed for the number of trap managers ( n) specified by the
Number of Trap Managers configuration option.
None – No Trap Manage n network destination. Traps are discarded.
IPBus – The Trap Manager n network destination is the IP Bus on the carrier backplane.
This selection only appears for carrier-mounted DSU/CSUs which are not configured as
the IP Bus Master.
Com – The Trap Manager n network destination is the communication port. This
selection only appears if the Com Use configuration option is set to Mgmt or Daisy.
Modem – The Trap Manager n network destination is the modem port. This selection
only appears if the Modem Use configuration option is set to Mgmt. This selection does
not appear on carrier-mounted DSU/CSUs.
Aux – The Trap Manager n network destination is the auxiliary port. This selection only
appears if the Aux Use configuration option is set to Mgmt or Daisy.
FDL – The Trap Manager n network destination is the FDL management link. This
selection only appears if the FDL management link is enabled.
EDL n – The Trap Manager n network destination is the EDLn port (where n is 1– 4). This
selection only appears if the synchronous data port’s EDL management link is enabled.
NOTE: If the chosen destination link is disabled or down, the traps are discarded.
Return to this menu and choose another destination.