Paradyne 3160 - Manual (Page 84)

Operation
3-50 3160-A2-GB21-80 March 1999
5. Use the and keys to position the cursor under the desired character.
You must enter a character before the moves the cursor to the next
space to the right.
F1
Passwd: xxxxxxxx
Up Down Save
F2 F3
6. Enter the desired password. Press F1 (Up) and F2 (Down) to scroll up and
down through the valid characters/numbers for the password. Valid password
characters are 0–9, a–z, A–Z, #, –, ., and /. Press F3 (Save) to save the
password.
F1
Passwd: xxxxxxxx
Up Down Save
F2 F3
Entering a Password to Gain Access
You are prompted to enter a password (up to 8 characters) when you are
accessing a port whose Password configuration option is set (refer to the
previous section,
Setting a Password ).
Valid password characters are 0 –9, a–z, A–Z, #, -, ., and /. The existing
password is not shown on the screen. An underscore in the first position shows
where to enter the first character. If the password is set to all null characters
(default value), press F3 (Done) when the password screen first appears.
The following screen appears when you access a DSU/CSU that has a password
enabled.
F1
Passwd:_
Up
Down Done
F2 F3