Planet Technology IPX-2000 - Manual (Page 16)

the information.
Associated Trunks
1
Select routegroups and outbound trunks accessible by this
usergroup. Note the order matters the hunting sequence in
run-time.
Routegroup: display available routegroups.
Trunk: Display available trunks.
Group ID: The default number is “0”. A trunk with Group ID
“0” does not form a balance group with any other trunks in
Group 0. If Group ID is 1~9, trunks with the same Group ID
form a usage balance group.
Weight: the weight of a trunk to be selected in a trunk
balance group for an outgoing call.
Click or to add or delete the associate trunks.
After add all trunks, click APPLY.
)
If there is not any appropriate SIP trunk and PSTN
trunks to select, you may assign trunks at Setp 5:
Assign Trunk in Add Route & Trunk wizard
configuration after trunks are created in the previous
step.
Reachable User Groups Select a usergroup and click ADD that is reachable from this
usergroup. By default, only users in the same usergroup can
reach one another.
)
If there is not any appropriate usergroup to select,
come back later to revise this selection, once more
usergroups have been created.
Associated PBX Features 2 Select PBX features enabled to this usergroup.
Member List Show the users associated with this usergroup.
Auth. Dial Passcode Select and enter a password in number for caller to have the
same privilege as this usergroup to dial out.
1 Please refer to 6.6, 6.7, and 6.8 for details.
2
Please refer to 7 for details.
5