Planet Technology IPX-2000 - Manual (Page 33)

4 System Configuration
This section describes how to configure system parameters used by IP PBX. Click Customize Setup
after login the web interface to configure the following system parameters.
4.1 PBX System
The PBX System page briefs IP PBX status to the administrator. Firmware versions, IP addresses of
WAN and LAN interfaces, and default gateway router are shown in this page. Click PBX System to
see the basic information of IP PBX.
4.2 Time Setup
The Time Setup page allows administrator to configure time zone and date for IP PBX. With correct
time setup, functions such as IVR, worktime, and voicemail can present the actions at the right time.
Select System -> Time Setup to see the current setting of time zone and date.
4.2.1 System Time Zone
1. Click a region/country in the Time Zone list.
2. Click Apply in System Timezone Setup.
3. Go to System -> Shutdown, select Rebooting After Shutdown and Click Yes to activate
changes.
4.2.2 Real Time Clock (RTC) Setup
1. Click year, month, day, hour, minute, and second in the correspondent list.
2. Click Apply in Real Time Clock Setup.
Note: When reset the time 15 minutes later than the time showed in RTC Setup, the system will ask for
re-login.
4.3 On-board WAN Setup
The On-board WAN Setup page allows administrator to configure WAN network interface for IP PBX.
Select System -> On-board WAN Setup, and the current setting of WAN network interface is
displayed, e.g. type, IP address etc.
22