Planet Technology IPX-2000 - Manual (Page 22)

voicemail will be recorded until the storage is full.
3.2 Add Route & Trunk
In Add Route & Trunk page, the administrator can setup routes, routgroups and trunks. Moreover,
worktime and IVR are included in this part for assigning to trunks. You can follow the following steps to
finish configuration. After finishing configuration, click at the bottom of the homepage to
take the configuration effect.
Step 1: Add Route
1. Enter settings shown in Table 3-6.
2. Click ADD to see the newly added route in the table in the webpage.
For deleting a route, select a route ID and click DEL.
Click Next to set a routegroup.
Table 3-6 Add Route Settings
Field Description
Route ID A unique ID containing alphabets, numbers, and underscore
only without spaces; 16 characters maximum.
Description Arbitrary description information.
Destination Number Pattern
5
A destination number pattern consisting of digits, digit set,
and wildcard characters, e.g. 9NXXXXXX matches any
7-digit called number starting from a digit larger or equal to 2
and with an extra prefix digit 9.
Prefix A sequence of digits to be prefixed to the final dialed number
after stripping. Using 9NXXXXXX as an example route
pattern with number of stripped digits equal to 1 and prefix
1408, dialing 95270001 will be 14085270001 when it
actually got dialed out.
A special prefix character “w” could be used for PSTN trunks
to pause 0.5 second during dialing. Say, 4 leading
5
For more information about the available digit set and wildcard characters, please refer to Table 6-7.
11