Oce North America TDS600 - Manual (Page 197)

Océ Power Logic: Settings Editor (for the key operator) 197
Timers
The Timers group allows you to adjust the following settings (see figure 114):
■ Sleep mode timer
■
Controller panel time out
[114] Timers settings for key operators.
Sleep mode time
Description Use ‘Sleep mode timer’, to specify after how many minutes of
inactivity the system should switch to Sleep mode. In Sleep
mode, almost all the power supplies are switched off. Note:
The sleep mode time-out also applies to the scanner and the
folder, but NOT to the controller.
Min/max values N/A
Menu path System - Timers - Sleep mode timer
Controller panel time out
Description Use ‘Panel time-out’, to set the panel time-out of the scanner
panel. When no settings are being selected and no original is
being scanned, the panel will switch to the default settings af-
ter this time out. By default this setting is ‘ON’. The default
panel time-out is 90 sec.
Min/max values N/A
Menu path System - Timers - Controller panel time out - <value> - Apply