Oce North America TDS600 - Manual (Page 61)

Use the Océ TDS600 to scan 61
Buttons
With the buttons on the operator panel you can make a number of settings for
the Océ TDS600.
The following buttons are available:
Section, Function and Arrow buttons
Apart from the above mentioned buttons, the operator panel of the Océ
TDS600 Copier contains a number of other buttons. These include:
■
Section buttons
■
Function buttons
■ Arrow buttons.
The section buttons are the four buttons located above the display. These
buttons provide access to the ‘Custom’, ‘Original’, ‘Print’ and ‘File’ sections
on the display.
Each section contains several functions (cards). These can be accessed with the
help of the left most function button, which is also called the card selection
button.
Button type
Function
Start buttons The green button marked with is used to start the
feeding of the original, or to re-start the copy process.
Numeric buttons The buttons with numbers on the lower part of the oper-
ator panel are used to enter numbers.
Correction button The orange button marked with C, located at the bottom
right of the operator panel. If you press the correction
button once, the copy counter is set to the default (prob-
ably ‘1’). If you press this button twice, all settings are
reset to their default values.
Stop button Pressing the red button to the left of the display stops the
copy process for the current original. You can stop the
original transport immediately when an original jam oc-
curs.
Interrupt button Currently not in use.