Oce North America TDS600 - Manual (Page 40)

40 Océ TDS600 Multifunctional Digital System User Manual
The controller starts up.
Switch the Océ TDS600 printer and scanner off
▼ ▼ ▼ ▼ Switch the Océ TDS600 printer off
Note: Ensure that the engine does not run.
1 Set the on/off switch at the rear of the printer to position ‘0’.
▼ ▼ ▼ ▼ Switch the Océ TDS600 scanner off
1 Set the on/off switch at the front of the scanner to position ‘0’.
▼ ▼ ▼ ▼ Switch the Océ Power Logic controller off
1 Select the ‘Shut down’ option from the System Control Panel.
2 Switch off the controller and the monitor (see figure 9).
Note: Wait at least 5 seconds before you restart the Océ TDS600.