Oce North America TDS600 - Manual (Page 34)

34 Océ TDS600 Multifunctional Digital System User Manual
Off-line folding settings
On the operating panel of the Océ TDS600 Printer you can specify the settings
you want to use for off-line folding. These settings include defining the length
and width of the folded package, enabling and defining the binding edge,
selecting the input method and legend position and cleaning the reinforcement
knive.
▼ ▼ ▼ ▼ Make off-line folding settings
1 Press the on line button on the printer operating panel to put the printer off line.
The message ‘Off line’ is displayed in the status window.
2 Activate the Folding option by pressing the left selection button.
The dotted line around the current selection is changed into an uninterrupted
line and the small selection triangles next to the specified option are no longer
dimmed.
3 Use the up/down buttons to switch between the available options.
4 Activate the Input option and press the right selection button to activate the
Legend option.
5 If necessary, change the value in the Legend field with the up/down buttons.
6 Press the right selection button again to activate the Method option.
7 If necessary, change the value in the Width field with the up/down buttons.
8 Press the left selection button again and use the up/down buttons to select
another option. This can be Package (with suboptions Length and Width),
Binding (with suboptions Size and Binding), or Special (with suboption
Knife).
9 Make any desired settings.
10 Put the printer on line again by pressing the on line button. The printer now
uses the specified off-line folding settings.
Positioning the reinforcement knives (optional)
Because the knives of the optional reinforcement unit of the folder get sticky
from the glue on the reinforcement tape, they have to be cleaned regularly. You
are recommended to clean the knives each time you have inserted a new tape
roll (see ‘A new tape roll’ on page 254) or when an error in the reinforcement
unit has occurred.
Before you can clean the reinforcement knives, you have to place them in such
a position that all the parts that need to be cleaned are accessible. You can do
this from the printer operating panel.