Oce North America TDS600 User Manual
Page 229
Océ Power Logic: Account logging
229
[124] The accounting directory with the account log file on the Océ TDS600 system
▼
▼
▼
▼
Get the account log file via FTP in a dos box
1
Launch an FTP client.
2
Enter the ‘ftp’ command.
A DOS box now appears with the FTP prompt.
3
Enter the ‘Open’ command followed by either the registered name of the
Power Logic Controller or the IP address (for example: 194.2.66.146) to
connect to the Controller and press Enter: ‘open 194.2.66.146’.
Note:
Instead of performing steps 2 and 3 you could also enter “ftp
host_name” in the FTP client.
The connection with the Controller is now established and a window appears
asking you for a user name.
4
Enter your user name ‘anonymous’, and enter as your password also
‘anonymous’.
A connection is now set up for the default user ‘anonymous’.
Note:
As there is no registered user, you can simply press Enter to initiate
the connection.
5
Set the transmission mode to binary by entering ‘binary’.
6
Go to the ‘logging’ directory using the following command: ‘cd logging\’.
7
Get ‘20001011.csv’ or ‘20001110.txt’ depending on the file format setting,
(see ‘File format’ on page 201).
8
Quit FTP by entering the ‘bye’ command.