Oce North America TDS600 - Manual (Page 247)

Media and supplies 247
[134] Adjusting the position of the right hand guide
3 Remove the packaging of the print material. In case of wrapped paper, also
remove the top and bottom sheets.
Note: If you use polyester as print material you have to fan the sheets before
you load them to avoid that they stick together.
4 Position the print material in the drawer against the front plate. The side to be
printed should be facing downwards.
Note: You can check if the material is properly loaded by looking through
the view holes in the drawer (see figure 134).
5 Adjust the right hand guide.
Note: Carefully place the print material in the drawer to avoid damage to
the media.
6 Slide the two other guides into position.
Also refer to the sticker inside the drawer.
7 Close the drawer.
Note: When you alter the size and/or media type, you have to adjust the settings
on the operating panel.
Attention: If you decide to reload print material when the drawer is not
entirely empty, it is recommended to remove all remaining print material
from the drawer before you insert the new print material. This way you can
avoid the risk of inadvertently shifting any remaining print material out of
place and blocking the path. This could result in a jam.
guide
release
handles
view holes