Oce North America TDS600 - Manual (Page 271)

Problem solving 271
Note: If the cut sheet feed covers are still flashing on the display, re-check the
sheet feeder section.
Paper jam in the roll feed section
▼ ▼ ▼ ▼ How to clear a jam in the roll compartments
1 Open the appropriate roll compartment.
Note: Only one compartment can be open at a time.
2 Remove any jammed printing material from the paper path (see figure 164)
and, if necessary, pull back the paper and rewind it.
Note: Occasionally, a jam may occur before the printing material has been
cut. In that case, you can cut the material manually by pressing the
appropriate green load button in the roll compartment.
3 Reload the roll if the system asks you to do so (see ‘Load rolls of copy
material’ on page 241).
4 Close the roll compartment again.
Note: If the roll feed covers are still flashing on the display, re-check the roll
feed section.
Paper jam in the manual feed
▼ ▼ ▼ ▼ How to clear a jam in the manual feed
1 Open the manual feed by tilting it towards you (see figure 165).
[165] Opening the manual feeder
2 Remove any jammed printing material.