Oce North America TDS600 - Manual (Page 50)

50 Océ TDS600 Multifunctional Digital System User Manual
[17] Selecting the input mode
Note: You can also select the input mode from the ‘Custom’ section (if this
setting has been defined for this).
Specify the zoom factor
You can use the ‘Zoom’ setting to select a zoom factor. If you select
‘Automatic’ with the ‘
● ’ symbol, the Océ TDS600 Copier will use a zoom
factor that is needed to obtain a copy without loss of information. This will be
done according to the selected media roll or sheet feeder. After inserting the
original, the zoom factor that is used is indicated by the ‘
❍ ’ symbol.
If you select the numeric zoom factor with the ‘ ● ’ symbol, you can define a
zoom factor yourself between 25% and 400%. After selecting the numeric
zoom factor, the four little triangles will appear to the right. Now you can
define a new zoom factor in two different ways:
■ By using the Arrow buttons on the right of the display (see figure 10 on
page 41). If you press one of the vertical buttons, the zoom factor will
increase or decrease with steps of 0.1%. If you press one of the horizontal
buttons, the zoom factor will increase or decrease with the steps predefined
in the Océ Settings Editor by the key operator.
■ By using the numeric buttons at the bottom of the operator panel. You can
specify the exact zoom factor with 0.1% increments.
For example, if you want to specify a zoom factor of 25.4%, you type 254. If
you want to specify a zoom factor of 254%, you type 2540.
▼ ▼ ▼ ▼ Selecting the zoom factor
1 Select the ‘Image’ card in the ‘Copy’ section.
2 Select the desired media with the ‘Zoom’ function button.
Access to
ial Access to
Page Interrupt
job