Tektronix 1760 - Manual (Page 44)

At A Glance
1760 Series Component Waveform/Vector Monitor User Manual
2-6
H Without PARADE or OVERLAY selected, only one input
selection can be made at a time. Each input channel
button (including
A123 / B123 ) toggles between A
and B , and is cancelled when another input button is
pressed.
H With PARADE or OVERLAY selected, multiple input
selections can be made; input buttons select A, B ,
both, or off, and do not cancel each other.
H Selecting
A123 provides a side-by-side display of the
CH-A1 , CH-A2 , and CH-A3 inputs ( B123 displays the
CH-B1 , CH-B2 , and CH-B3 inputs). Selecting A123 or
B123 turns off all other input channels. When
PARADE or OVERLAY is selected, A123 and B123 can
be displayed together and in combination with other
inputs.
H PARADE displays up to four input channels side-by-
side, with any additional inputs overlaid. Selecting
PARADE displays the input channel(s) last selected
for PARADE, allowing a custom configuration of
inputs. In PARADE mode, the LINE/FIELD button
offers only two choices: one line and one field.
H OVERLAY provides an overlaid display of all se-
lected inputs.
MENU
Push the desired menu button to enter that menu and enable
the associated functions. Push the button again to exit the
menu and disable the function. Refer to page 3-7 for more
information about using menus.
H
FILTER allows choice of flat or filtered display of the
waveform signal.
H CURSOR enables timing cursors, voltage cursors,
vector cursors and markers.
H
LIN SEL allows the selection of a single line or group
of lines for display.