Configure menu, Input, Push the – Tektronix 1760 User Manual
Page 88: Selects ac or dc coupling for rear-panel inputs. h, Sync tip) or, Back porch)
Using the Menus
1760 Series Component Waveform/Vector Monitor User Manual
3-20
Configure Menu
Push the
CONFIG
button to display the configure menu,
shown in Figure 3-6. Turn the left bezel control to select
INPUT, VECTOR, FORMAT, STANDARD, OFFSET, CALIBRATE,
REMOTE
,
or
REFERENCE
(a box appears around the selec-
tion). Following are descriptions of each selection.
INPUT
H
COUPLING
—
Selects AC or DC coupling for
rear-panel inputs.
H
DC RESTORER
—
Selects the clamp speed. Slow
will clamp while displaying any hum.
H
CLAMP
—
Selects the point of the video signal that is
clamped to 0. Can be set for
ST
(sync tip) or
BP
(back porch).
VERTPOS
HORIZPOS
CLEAR
MENU
Bezel
Buttons
Left
Center
Right
INPUT
VECTOR
FORMAT
STANDARD
OFFSET
CALIBRATE
REMOTE
REFERENCE
COUPLING
AC
DC
DCRESTORER
SLOW
FAST
CLAMP
ST
BP
A123
COMPOSITE
COMPONENT
B123
COMPOSITE
COMPONENT
Figure 3-6. The
CONFIGURE
menu display with INPUT selected.